Hammer Header Male - Solderless Raspberry Pi Connector

GPIO Hammer Header (Solderless) – Male

Absolutely no soldering required! All that's needed is a few gentle taps with a hammer and bazinga! Your header is securely attached to your Pi Zero or pHAT.

If your soldering isn't quite up to scratch, or you just don't own a soldering iron yet, then these nifty hammer headers might be just the job. This is the male flavour, and uses crafty little retaining nubbins to grip tightly into the holes on the PCB.

Make sure you carefully read the guide for fitting hammer headers, and use a sturdy, stable, well-supported surface while hammering.

We strongly recommend using our installation jig, sold separately. If you want to try without it then godspeed to you but it is a delicate and tricky process! The female headers are simpler to insert than the male headers as you can hammer straight onto the plastic of the header, but the male ones are particularly tricky without the jig.

Please note: we can't be held responsible for any damage that you may cause to your Pi Zero, pHAT, fingers, or headers while fitting them. If you follow our guide carefully then you should be fine. If this worries you, then get yourself a soldering iron instead!