Raspberry Pi PoE HAT

This version is no longer in production, please see the newer POE plus here.

This is the newer version of the PoE HAT, unaffected by the "underachieving USB current" syndrome.

Important note: not all Pi cases are PoE HAT compatible. Please check short video below that should help you to pick right case for your PoE HAT project:

PoE HAT case options

• HighPi Raspberry Pi B+/2/3 Case – Black (Perfect fit)
• HighPi Raspberry Pi B+/2/3 Case – Clear (Perfect fit)
• ModMyPi Modular RPi B+/2/3 Case – Black (Fits, but Pi board cannot be secured to case)
• Official Raspberry Pi 3 B Case, Black, Grey (Fits, but Pi board cannot be secured to case)
• Official Raspberry Pi B+/2/3 case – White and Red (Fits, but Pi board cannot be secured to case)

The official Power over Ethernet add-on board for the Raspberry Pi 3 Model B+ and Raspberry Pi 4B. Use this HAT to power a Raspberry Pi via an Ethernet cable!

Features

• 802.3af PoE standard
• Fully isolated switched-mode power supply
• 37–57V DC, Class 2 device
• 5V/2.5A DC output
• 25mm x 25mm brushless fan for processor cooling
• Fan control, fan only runs when necessary

Compatibility

For Raspberry Pi 3 Model B+ and Raspberry Pi 4B only.

Included

• Raspberry Pi PoE HAT
• 10mm standoffs x 4

Other hardware needed

• Power-sourcing equipment for a 802.3af Power over Ethernet network
• An Ethernet cable
• A Raspberry Pi 3 Model B+

GPIO Access with PoE HAT

The GPIO pins can be accessed while the PoE HAT is used, but additional components are required;

• GPIO Stacking Header for Pi – Extra-long 2×20 Pins
• 2X2 Pin, 2.54mm Double Row Female Straight Header
• Brass Standoffs, M2.5 x 15mm, Package of 4

5mm of the GPIO pins are then available above the top surface of the PoE HAT board for your desired use.