Snap-on Enclosure for Raspberry Pi Pico / W / 2 / 2W

Here is a cute and minimal enclosure for your Pi Pico to keep it safe during use and transport. This case has been custom-designed and 3D printed to accommodate the Micro USB and Bootloader button press with venting through the top cover. No screws or glue are required; simply snap the Pico into the bottom piece and assemble the top piece.

If you want to connect accessories on top, like a PiCowbell, simply leave the cover off.

It's made of translucent milky white plastic with an SLA process, so you can still easily see the power good LED shining through, and there are no lines or blobbiness to the print.

Comes with two snap-together plastic pieces. No boards, cables, or accessories are included. Designed for the Raspberry Pi Pico, Pico W, Pico 2 and Pico 2 W! It should also work with any Pico-like board as long as the button and micro USB connector is in the same spot.

Technical Details

Dimensions for assembled enclosure (including ear mounts): 56.09mm x 41.80mm x 11.40mm

Product Dimensions: 56.1mm x 41.8mm x 11.4mm / 2.2" x 1.6" x 0.4"

• 3D Render Bottom
• 3D Render Top