Categories - PiShop.ca

Sub Categories

Features Item Name Alkaline Battery LR6 AA Nominal Voltage: 1.5 V Average Weight:23±1g Average Height: 49.2-50.5mm Average Diameter:13.5-14.5mm Discharging Time:350Minutes Jacket: Aluminum Foil Specifications LR6 1.5v alkaline batteries...

Add to Cart

2x AA Battery Holder with JST Connector

$0.00

For micro:bit kits, hidden for now.

Notify Me

USB to Micro-USB cable, 45cm, Black (USB 2.0)

$2.95

We think this USB-A to micro-USB B cable is the perfect length, at 45cm/1.5ft. Black in color. This cable is male USB(A) to male micro-USB(B), USB 2.0. Compatible with micro:bit, Raspberry Pi (up to Pi 3B+) and many Arduino boards.

Add to Cart

Pololu Carrier for MQ Gas Sensors (Bare PCB Only)

$0.95 $1.95

This breakout board is designed to work with any of the MQ-series gas sensors, simplifying the interface from 6 to 3 pins—ground, +5V VCC, and an analog voltage output—that are broken out with a 0.1" spacing, making the board compatible...

Notify Me

Project Box 1 for Raspberry Pi

$22.95

MONK MAKES - PROJECT BOX 1 FOR RASPBERRY PI The Project Box for Raspberry Pi contains all the components needed, to make 10 great electronic projects with your Raspberry Pi: Blinking LED Blinking two LEDs Color display using an RGB (Red,...

Add to Cart

RasPiRobot Rover Kit

$64.95

Build your own Robot Rover for Raspberry Pi - just add Raspberry Pi and batteries. The kit includes: RasPiRobot Board v3 Raspberry Squid Raspberry Squid Button Range Finder Car Chassis 2 Gear Motors 2 Wheels Castor 2 Screwdrivers 6AA Battery Box...

Notify Me

Electronics starter kit for Micro:Bit

$57.95

This kit contains everything needed to start learning about connecting electronics to the micro:bit in an accessible and easy manner. Everything is connected using the supplied alligator clips, so no soldering required. This kit suitable for children as...

Add to Cart

Finch Robot

$79.95 $149.95

The Finch is a robot for computer science education. Its design is the result of a four year study at Carnegie Mellon's CREATE lab. The Finch is designed to support an engaging introduction to the art of programming. It has support for over a dozen...

Notify Me

Adafruit I2S 3W Stereo Speaker Bonnet for Raspberry Pi - Mini Kit

$22.94

Hey Mr. DJ! Turn up that Raspberry Pi mix to the max with this cute 3W Stereo Amplifier Bonnet for Raspberry Pi. (It's not big enough to be an official HAT, so Adafruit called it a bonnet, you see?) It's the exact same size as a Raspberry...

Add to Cart

Nylon 12mm M2.5 Standoff Set - Pack of 4

$0.95

Nylon Standoffs - M2.5x12mm - Pack of 4 - Black

Add to Cart

Stereo Enclosed Speaker Set - 3W 4 Ohm

$12.94

Listen up! This set of two 2.8" x 1.2" speakers are the perfect addition to any audio project where you need 4 ohm impedance and 3W or less of power. Adafruit likes these speakers as they are small and enclosed for good audio volume and quality. The pair...

Add to Cart

Standalone Momentary Capacitive Touch Sensor Breakout - AT42QT1010

$9.94

This breakout board is the simplest way to create a project with a single "momentary" capacitive touch sensor. No microcontroller is required here - just power with 1.8 to 5.5VDC and touch the pad to activate the sensor. When a capacitive load is...

Add to Cart

DC-To-Type-C USB Adapter Cable for BOSS Dac v1.2

$2.45

DC To Type-C USB Adapter Cable to be used with the BOSS Dac v1.2. Features 5.5mm x 2.5mm DC female input to TypeC USB male 18 AWG 17cm total length Input: 5.5mm x 2.5mm DC female to type c cable

Notify Me

micro:bit RED LED

$4.75

A 3V Light Emitting Diode as an additional LED. It uses a high brightness low current LED and includes a current limiting resistor to protect the micro:bit’s output. The black lead goes on to GND and the green lead goes on to whichever Pin 0, 1...

Add to Cart

micro:bit Transistor

$3.95 $8.50

A transistor that will allow other items to be switched where the micro:bit would not be able to. Items such as motors, larger speakers, relays and so forth, up to 1A total load. A current limiting resistor is in the circuit to protect the micro:bit...

Add to Cart

micro:bit Buzzer

$5.95 $7.50

A simple buzzer with transistor that can be powered by the micro:bit. Costs more than a headphone adapter but far less than the mini-speaker - its best use is to act as an sounder for an alarm or similar.

Add to Cart

micro:bit Passive Infrared Movement Detector

$8.95 $10.95

A small version of the PIR that is used in a typical burglar alarm. It triggers when a warm body passes in front of the detector. It has some range / sensitivity setting capability and the duration of the output can be set. The black lead goes on to...

Add to Cart

micro:bit Water Pump

$18.75

A small submersible pump designed for Ph neutral, ambient temperature, non-sticky liquids, ie water. It has a transistor interface with current limiting resistor to the micro:bit output and needs ~8V power to run. The black lead goes on to GND, the green...

Notify Me

micro:bit Sound Level Detector

$8.45 $9.50

A small microphone with amplifier & threshold setting. It can detect when sound reaches a certain level. It can not detect a particular frequency and there is no support in the micro:bit programming environment at present for it to analyse...

Add to Cart